E-flite Tribute FX 3D ARF - Manual (Page 14)

1 E-flite Tribute Fx 3D ARF Assembly Manual
 14. Wrap a small piece of tape on the string where it
crosses the stabilizer tip. Mark the tape to indicate the
exact location of the stabilizer tip. Swing the tape over
check the position of the opposite stabilizer tip. If these are
not equal, reposition the stabilizer and tape and repeat
until the mark on the tape aligns with both stabilizer tips.
 15. Check the alignment of the stabilizer to the wing. The
stabilizer must be parallel to the wing. If not, lightly sand
the opening in the fuselage to correct any alignment issues.
Parallel
 16. Use foam-safe CA to glue the stabilizer to
the fuselage.