E-flite Tribute FX 3D ARF - Manual (Page 13)

13 E-flite Tribute Fx 3D ARF Assembly Manual
 10. Place a support under the wing so the fuselage is not
touching the work surface. Use weights to hold the fuselage
tight against the wing while the CA cures.
 11. Use thick foam-safe CA to glue the belly pan to the
wing. It may be necessary to lightly sand the belly pan to fit
perfectly to the contour of the wing.
 12. Slide the stabilizer through the slot in the
fuselage. Measure each side of the stabilizer to
make sure it is centered.
 13. Place a T-pin at the front of the fuselage as shown.
Tie a string to the T-pin that is long enough to reach
beyond the stabilizer tip.