E-flite Hawker Hurricane 25e PNP User Manual
Page 8
8
E-flite Hurricane 25e PNP/BNF Assembly Manual
EN
2. Fit the stabilizer half to the fuselage by sliding the
tube into position. The stabilizer will fit tightly in the
plastic fairing.
3. Fit the other stabilizer half into position. Both
halves will fit tightly in the fairing when installed.
If not, check to make sure there is nothing from
preventing them from seating fully.
Follow the procedure listed to apply the epoxy that
will secure the tube in the stabilizer halves. This will
allow you to remove the tube and stabilizer pieces
from the fuselage if the stabilizer becomes damaged.
4. Remove the stabilizers from the fuselage, and
the tube from both stabilizer halves. Apply a small
amount of 30-minute epoxy to the end of the
stabilizer tube and to the tube socket.
5. Slide the tube into the stabilizer half. Use a paper
towel soaked with denatured alcohol to remove any
excess epoxy. Apply a small amount of petroleum
jelly to the first .50-inch (13mm) of the tube exposed
outside of the stabilizer.
6. Slide the stabilizer in position as shown in step
2. Apply a small amount of epoxy to the end of the
stabilizer tube and in the stabilizer as shown in step
4. Slide the remaining stabilizer into position.