E-flite Hawker Hurricane 25e PNP - Manual (Page 18)

18 E-flite Hurricane 25e PNP/BNF Assembly Manual
EN
Center the Control Surfaces - BNF/PNP
Required Parts
Canopy hatch Assembled airframe
Transmitter Antenna mast
 1. Turn on the transmitter and connect the motor
battery to the speed control. Verify the operation of
the servos.
 2. Center the trims and sticks for the aileron, elevator
and rudder. Also make sure the sub-trims for these
surfaces are set to 0%. Verify the alignment of the
servo arm is 90 degrees to the servo case. If not, use
sub-trim to adjust this alignment.
 3. Center the control surface and adjust the clevis so
that it will attach.
 4. Place the canopy hatch on the fuselage.
 5. Fit the antenna mast to the fuselage.
Remove the antenna mast during transport
or when working on your model so it
does not get lost or damaged.