E-flite Hawker Hurricane 25e PNP - Manual (Page 4)

4 E-flite Hurricane 25e PNP/BNF Assembly Manual
EN
Required Tools and Adhesives
Tools & Equipment
Balancing stand Cut-off wheel
Epoxy brush Drill bit: 3/16-inch (5mm)
Flat file Mixing cup
Mixing stick Open-end wrench: 3/4-inch
Paper towel Petroleum jelly
Rotary tool Phillips screwdriver: #1
Ruler Vise grip
Hex wrench: 2.5mm
Hobby knife with #11 blade
Adhesives
30-minute epoxy PAAPT39
Threadlock PAAPT42
During the course of building your model, we suggest
you use a soft base for the building surface. Things like
a foam stand, large piece of bedding foam or a thick
bath towel will work well and help protect the model
from damage during assembly. This is not shown in the
instructions to provide the greatest detail in the photos.
When referencing directions (up, down, left,
right, top and bottom), these directions are in
relationship to the pilot sitting in the cockpit
of the aircraft unless noted otherwise.
Charging the Flight Battery - BNF
Required Parts
Charger Motor battery
12V power supply or AC adapter
BATTERY WARNINGS
The Battery Charger included with your aircraft is
designed to safely charge the Li-Po battery.
CAUTION: All instructions and warnings
must be followed exactly. Mishandling of Li-Po
batteries can result in a fire, personal injury,
and/or property damage
• By handling, charging or using the included Li-Po
battery you assume all risks associated with lithium
batteries.
• If at any time the battery begins to balloon or
swell, discontinue use immediately. If charging or
discharging, discontinue and disconnect. Continuing
to use, charge or discharge a battery that is
ballooning or swelling can result in fire.
• Always store the battery at room temperature in a
dry area for best results.
• Always transport or temporarily store the battery
in a temperature range of 40–120º F. Do not store
battery or model in a car or direct sunlight. If stored
in a hot car, the battery can be damaged or even
catch fire.
• NEVER USE A Ni-Cd OR Ni-MH CHARGER. Failure
to charge the battery with a compatible charger
may cause fi re resulting in personal injury and/or
property damage.
• Never discharge Li-Po cells to below 3V under load.
• Never cover warning labels with hook and loop strips.
• Never leave charging batteries unattended.
• Never charge batteries outside safe temperature range.
• Never charge damaged batteries.
Your model comes with a DC balancing charger and
3S Li-Po battery. You must charge the included Li-Po
battery pack with a Li-Po specific charger only (such
as the included charger). Never leave the battery and
charger unattended during the charge process. Failure
to follow the instructions properly could result in a
fire. When charging, make certain the battery is on a
heat-resistant surface. Charge the flight battery while
assembling the aircraft. Install the fully charged battery
to perform control tests and binding.
DC LI-PO BALANCING CHARGER FEATURES
• Charges 2- to 3-cell lithium polymer battery packs
• Variable charge rates from 300mAh to 2-amp
• Simple single push-button operation
• LED charge status indicator
• LED cell balance indicator
• Audible beeper indicates power and charge status
• 12V accessory outlet input cord Specifications
• Input power: 12V DC, 3-amp
• Charges 2- to 3-cell Li-Po packs with minimum
capacity of 300mAh
The included 3S Li-Po battery pack features a
balancing lead that allows you to safely charge
your battery pack when used with the included Li-Po
balancing charger.
NOTICE: Do not use a 6V power supply with
this charger.