E-flite Hawker Hurricane 25e PNP - Manual (Page 6)

6 E-flite Hurricane 25e PNP/BNF Assembly Manual
EN
 2. Remove the spinner cone by pulling the cone
forward from the spinner backplate.
 3. Use a 3/4-inch box wrench to remove the
propeller nut from the motor adapter.
 4. Remove the propeller from the motor adapter.
We recommend removing the spinner backplate and
propeller adapter during the binding process as they
can come loose if the motor starts and could cause
damage to your work surface or personal injury.
 5. When installing the propeller, use only the
recommended 11.75 x 7 propeller listed. Use of
a different sized propeller will change the load on
the motor, and could damage the motor or speed
control. Make sure the numbering on the propeller
faces to the front of the model as shown. Tighten the
nut to ensure the propeller is secure.
 6. Place the spinner cone in position and secure
it using the 3mm x 8mm machine screw and a
#1 Phillips screwdriver. Make sure to position the
spinner cone so it does not contact the propeller.
Battery Installation - BNF/PNP
Required Parts
Fuselage assembly Motor battery
 1. Remove the canopy hatch from the fuselage
by lifting the hatch at the rear. The canopy hatch
attaches to the fuselage using a magnet at the rear
and pins at the front.
 2. Locate the motor battery. If you are building
the BNF version of this model, we recommend the
battery be charged before it is installed. Slide the
battery under the hook and loop straps. Use the
straps to secure the battery in the fuselage.
Do not connect the lead from the battery to
the speed control until instructed to do so.