Hinkley Lighting HARLOW 4218PN User Manual
Start here, Assembly instructions

assembly instructions
Family: Harlow Item No. 4213 / 4216 / 4218
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the main
body of the fixture, making all necessary electrical connections, hanging the fixture
from the ceiling and then installing the fixture shade.
start here
4213
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Note: It will be necessary to determine the length of rods you will require to hang your
fixture at the desired height. After this has been established, please follow the
instructions below.
Drawing 1 - Assembly
Drawing 2 - Assembly
01.01.12
1. Slip first rod section (B) along wire and thread into top of main fixture body (A).
2. Slip next section of rod (C) along wire and thread into top of previously installed
rod - See Drawing 1.
3. Continue adding sections of rod until all necessary length have been attached to
the fixture.
4. Fixture can now be mounted to the ceiling by following mounting instruction sheet
(IS19-91) provided.
B
C
A
C
4216 4218
1
2
3
1. To install glass (1), pinch spring clip (2) together and slip ends of clips onto hole in
bottom of glass - see Drawing 2.
2. Slowly release clips (2) and slip glass (1) down into position on glass holder (3).
3. Fixture can now be lamped accordingly.
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com