Hinkley Lighting CORDILLERA 4094RI - Manual

assembly instructions
Family: Cordillera Item No. 4094 RI
*** The construction of this fixture will be accomplished by first assembling main
body, making all necessary electrical connections, hanging the fixture and then
installing the fixture glass.
start here
4094
Drawing 1 - Glass Installation
Drawing 2 - Glass Installation
1
1
12
A
B
1 A
12.29.08
paper towels or
thin rag strips
3
3
Drawing 2 - Arm Rotation
1. Thread loop (1) onto nipple (2) - see Drawing 3.
2. Rotate arms (C) by grasping the top and bottom, until they are 90 degrees apart
and vertically straight - see Drawing 2.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
1. Fixture can now be lamped accordingly.
2. To prevent fixture glass from being scratched or chipped during installation, it is
recommended that strips of paper towels or a thin rag be draped over glass ring (A) - see
Drawings 1 and 3.
3. Slip glass (3) through ring (A) and into glass holder (B).
4. Repeat steps 2-3 for remaining glass.
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com