Hinkley Lighting BROADWAY FR41435PAL - Manual (Page 2)

CABLE HANGING INSTRUCTIONS
FRIS19-30
SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply off during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.
STEP 1
1 Shut off electrical current before starting. If the fixture you are replacing is
turned on and off by a wall switch, simply turn the switch off. If not, remove the
appropriate fuse (or open the circuit breakers) until the fixture is dead.
• DO NOT restore current - either by fuse, breaker or switch - until the new
fixture is completely wired and in place.
STEP 2
1 It will be necessary to determine the length of cable (f) that you will require to hang the fixture
at the proper height. To get an approximate lenght of cable requried, measure
the distance between the floor and the ceiling and subtract the distance the fixture
will be above the floor. The remainder is the approximate lenght of cable required.
2 To aid in hanging, the cables (f) can be measured from the top of the fixture and marked
with a piece of tape at the approximate length required.
3 To prepare cables for installation, first slide one cover cap (d) onto each cable (f), small end
first. Then feed one cable throught the appropriate holes in the canopy (c) - see Drawing 1.
4 Take mounting assembly (a) and feed one cable (f) through the cable locking mechanism
(e) and pull cable through and up to the previously measured point. NOTE: cable locking
mechanism will lock cable in place when pulled down. To release cable for adjustment
read instructions under Drawing (2).
5 Fixture can now be hung. This is accomplished by first threading 2 screws (b) into appropriate holes
in junction box. Do not tighten at this time.
6 Get assistance during this operation. Lift mounting plate (a) with fixture attached, up to junction box
(j) slip heads of previously installed screws (b) through keyhole slots (k) and twist, till screws
hit end of slot. Then thighten screws (b) to secure mounting plate (a).
7 Take supply wire (i) and feed through wire keeper (g) on canopy and up to junction box.
Allow approcimately 6” of slack in the supply wire (i) so it will hang in a lazy “S” fashion.
Make all necessary electrical connections by following instruction sheet FRIS-18 supplied.
8 Final cable adjustments can be made at this time, to level fixture and adjust height.
9 Slip canopy (c) up along cables (f) and supply wire (i), over mounting assembly (a), and up to
ceiling. Slip cover caps (d) align cables and thread onto cable locking mechanism (e) to
secure canopy to mounting assembly.
10 To secure supply wire location tighen screw (h). NOTE: do not over tighten and damage wire.
Note: If during the adjustment process too much cable is pulled up, the spring loaded
locking mechanism can be released by taking a screw driver and pushing up on the
center cylinder of the locking mechanism. This will release the spring pressure and
allow the cable to be pulled back out (use caution to prevent the cable from being damaged).
[DRAWING 1]
[DRAWING 2]
06.01.11
screwdriver
outside cylinder
800.421.3517 WWW.FREDRICKRAMOND.COM
e
d
a
j
k
e
h
b
c
g
f i