Hinkley Lighting BROADWAY FR41435PAL - Manual

fR41433, fR41434 fR41435pal
BROADWAY
ASSEMBLY INSTRUCTIONS
Assembly of this fixture will be accomplished by first determining the length of stem
required, attaching the mounting strap to the junction box, making all necessary
electrical connections, hanging the fixture from the ceiling and then installing the
lamps.
SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply off during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.
STEP 1
[DRAWING 1]
[DRAWING 2]
Bulbs: 60W g-9. Replacement Parts: GLASS: R41430GL
06.01.11
[DRAWING 3]
r
t
1
3
2
1 Follow mounting instruction sheet FRIS19-30 provided with fixture. After installation
return to this section of the instructions on lamping the fixture.
STEP 2
1 To lamp center hub of fixture, remove glass retainer ring (2) frombottom of the
main body (1). NOTE: the glass retainer ring is held in position by spring tension
and can be easily removed by pulling firmly on the edge at the split line. Retainer
ring is attached to the fixture by a wire cable (3) and will not fall when
released - See Drawing 1.
STEP 3
1 To lamp remaing hubs (5) , remove the top protective screen (4) by lifting them off
of the top main body assembly by pulling up on them with the aid of the assistance
hole punch in the edge of the screen. These lids are held in position by spring
tension and can be removed easily. After lamping the protective screen can be
snapped back into place - see Drawing 2.
Fixture is complete.
1 Glass is held by a “C” shape spring ring (r). To remove, replace, or install glass
it is necessary to pinch the two short tabs (t) of the ring together, after glass is installed ring
can be replaced in same manner -see Drawing 3.
STEP 4
4
5
2