Hinkley Lighting SPLENDOR 4924BN - Manual

assembly instructions
Item No. 4924
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the main
body of the fixture, making all necessary electrical connections, hanging the fixture
from the ceiling and then installing the fixture shade.
start here
4924
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Note: It will be necessary to determine the length of rods you will require to hang your
fixture at the desired height. After this has been established, please follow the
instructions below.
Drawing 1 - Assembly
Drawing 2 - Assembly
1.1.13
2. Slip next section of stem (A) along wire and thread into top of previously installed
stem .
3. Continue adding sections of stem (B) until all necessary length have been attached to
the fixture.
4. Fixture can now be mounted to the ceiling by following mounting instruction sheet
(IS19-82) provided.
B
A
1. Slip 18” stem (1) along wire and thread onto top of body (2) and tighten- see
Drawing 1.
1
2
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com
5. After fixture is mounted to ceiling, slip cap (3) over threaded tube (C) at bottom of
fixture. Hold in place and thread decorative ball (4) onto threaded tube (C) and
tighten - see Drawing 1.
3
4
6
5
1. To complete assembly slip glass bobesche (6) over socket (5) - see Drawing 2.
2. . Fixture can be lamped accordingly at this point, and power can be restored.
C