Hinkley Lighting OMNI FR47209PNI User Manual
Omni

FR47204, 47206, 47208, 47209PNI
OMNI
ASSEMBLY INSTRUCTIONS
The construction of this fixture will be accomplished by first assembling the main body
of the fixture, making all necessary electrical connections, hanging the fixture from the
ceiling and then installing the fixture shade.
SAFETY WARNING:
Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply off during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.
STEP 1
Note: It will be necessary to determine the length of rods you will require to hang your
fixture at the desired height. After this has been established, please follow the
instructions
belo w.
1
Assemble the rods (b) by slipping them into the wire. Thread the first rod into
the coupler (a) located at the top of the fixture - See Drawing 1.
2
Continue adding rods (b) until desired length has been reached.
STEP 3
Refer to Hanging Instruction Sheet [FRIS19-81] to hang fixture.Then refer
back to this sheet to continue fixture installation.
STEP 4
[DRAWING 1]
Bulbs:
60W G9
Replacement Parts:
GLASS: R47200GL, T47200BLSH
01.01.12
800.421.3517 WWW.FREDRICKRAMOND.COM
a
b
b
REQUIRED
LENGTH
1
2
[DRAWING 2]
To install glass slip glass (3) over socket (2)- see Drawing 2
Slip spacer (1) over socket (2).
Fixture can be lamped at this time with G-9 bulbs supplied.
Thread bulb shield (4) onto socket (2) and hand tighten only to secure glass.
Repeat for remaining pieces of glass.
3
4
3
4
1
2
1
2
3
To assembly center colum, first slip center tubing (2) along wire and thread into coupler
(1), located on the top of the center body (CB).
Slip square center tube (3) over center tubing (2), making sure it is seated over small
raised block located on the top of the center body (CB).
Thread coupler (A) onto end of center tubing (2) and tighten to secure assembly.
Fixture body is complete.
1
2
3
4
STEP 2
5
CB
install
lamp
before
installing
glass
: Fixture should be lamped accordingly at this point before proceeding.
Note