Start here, I.s.19-81 – Hinkley Lighting PRINCETON 4073BN User Manual

Page 2

H I N K L E Y L I G H T I N G

33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com

1. Shut off electrical current before starting. If the fixture you are replacing is
turned on and off by a wall switch, simply turn the switch off. If not, remove
the appropriate fuse (or open the circut breakers) until the fixture is dead.

• DO NOT restore current - either by fuse, breaker or switch - until the new
fixture is completely wired and in place.

start here

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS
( IS-18) AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF
DURING INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A
QUALIFIED ELECTRICIAN OR LOCAL AUTHORITIES FOR

REQUIRMENTS.

Drawing 1 - Fixture Assembly

I.S.19-81

hanging instructions

I.S

. 19-81

1. In the following order : take retainer ring (L) , canopy (H) and slide them
over the stems (R) attached previously.
2. Thread supply wires (S) through center of swivel (E) that is attached to
mounting strap (A).
3. Slide swivel with mounting strap along wire and thread end of swivel

into top of stems (R).
4. Lift fixture and attach mounting strap (A) to junction box (C) using
2-8/32 screws (B).
5. Make all necessary electrical connections following instruction sheet
(IS-18) provided. Ground wire (D) can be attached to mounting strap (A)

using green ground screw (G).
6. Slip canopy (H) up along rods (R) and over mounting strap with swivel
and hold in position.
7. Slip retainer ring (I) up to canopy and thread onto coupler (F), to secure
canopy.

8. Return to assembly instructions to complete fixture construciton.