Banner WORLD-BEAM QS30 Water Sensor - Manual (Page 5)

Specifications
NOTE: Specifications are subject to change without notice.
Supply Voltage
Emitter: 10 to 30V dc (10% maximum ripple) at less than 80 mA
Discrete Receiver: 10 to 30V dc (10% maximum ripple) at less than 65 mA (exclusive of load)
Analog Receiver: 15 to 30V dc (10% maximum ripple) at less than 65 mA (exclusive of load)
Beam
1450 nm, infrared
13 mm effective beam diameter
Sensing Range
Low-gain models: 2 m (6.5')
High-gain models: 4 m (13')
Super High-Power models: 8 m (26')
Output Configuration
Discrete models: Bi-polar current sinking (NPN) white wire; current sourcing (PNP) black wire
Analog models: 0–10V (black wire)
Output Rating
Discrete models: 100 mA maximum load @ 25° C
OFF-state leakage current: less than 10 µA
ON-state saturation voltage:
PNP: less than 1.2V at 10 mA; less than 2.5V at 100 mA
NPN: less than 200 mV at 10 mA; less than 1V at 100 mA
Protected against false pulse on power-up and continuous overload or short circuit
Analog models: 2 KΩ minimum impedance
Output Response
Discrete models:
10x excess gain or more — Standard models: 1 ms ON and OFF response; 500 µs repeatability
Super High-Power models: 10 ms ON and OFF response; 5 ms repeatability
2x to 10x excess gain — Standard models: 3 ms ON and OFF response; 2.5 ms repeatability
Super High-Power models: 30 ms ON and OFF response; 25 ms repeatability
Analog models: 25 ms for a 95% step change
Adjustments
Light Operate/Dark Operate — depending on model selected
Frequency — selected via gray wire
A: Gray (+)
B: Gray (–)
Emitter only: LED inhibit — selected via white wire
White (–) turns emitter LED OFF (to allow verification of receiver operation)
Indicators
Green LED on housing top: Power ON
Receiver only:
Yellow AID LED on housing top: Flashes to indicate signal strength (faster flash = better signal)
Yellow LED (large oval on housing back): Discrete output conducting
Environmental Rating Leakproof design rated IEC IP67 (NEMA 6); PW12 1200 psi washdown per NEMA PW12
Construction
Housing: plastic (PC/ABS blend)
Front window: plastic (PMMA -acrylic)
Cable: PVC
Pigtail QD: PVC and nickel-plated brass
Connection 5-wire 2 m or 9 m cable (6' or 30') or 150 mm (6") pigtail with 5-pin Euro-style quick-disconnect fitting
Operating Conditions
Temperature: −20° to +60°C (−4° to +140°F)
Relative Humidity: 95%; non-condensing
Certifications
WORLD-BEAM QS30H2O Series
P/N 136166 rev. C www.bannerengineering.com - tel: 763-544-3164 5