Banner WORLD-BEAM QS30 Series - Manual (Page 8)

The sensor toggles between enable and disable settings and returns to RUN mode.
Bar Graph Indicator Functions
Run Mode. The lighted bar graph segment represents relative distance from the cutoff point. Its behavior depends on whether a sensing
window or a sensing threshold is taught.
Sensing Window
Above window
Inside window
Below window
Switching Threshold
Above threshold
Below threshold
More light
Signal intensity
Less light
Signal intensity
Specifications
General Performance
Sensing Beam
660 nm visible red
Power
Supply voltage: 10 to 30V dc (10% max. ripple) @ 25
mA max current, exclusive of load
Supply protection circuitry: Protected against reverse
polarity, over voltage, and transient voltages
Delay at power-up: 250 ms; outputs do not conduct
during this time
Adjustments
2 push buttons and remote wire
Easy push-button configuration; manually adjust (+/–)
cutoff (push buttons only); Light Operate/Dark Operate
and OFF-delay configuration options (push buttons on-
ly); Push-button lockout (from remote wire only)
Indicators
8-segment red bar graph: distance relative to cutoff
point
Green LED: Power ON
Yellow LED: Output conducting
Construction
ABS plastic housing; acrylic lens cover
Connections
5-conductor 2 m (6.5 ft) PVC cable, 9 m (30 ft) PVC ca-
ble, or 5-pin integral Euro-style quick-disconnect fitting
Output Configuration
Bipolar: 1 current sourcing (PNP) and 1 current sinking
(NPN)
Output Ratings
150 mA maximum load (derate ~ 1 mA/°C above 25
°C)
OFF-state leakage current: < 50 μA at 30V dc
ON-state saturation voltage (NPN): < 200 mV @ 10
mA; < 1V @ 150 mA
ON-state saturation voltage (PNP): < 1.25V @ 10 mA;
< 2V @ 150 mA
Output Protection
Protected against output short-circuit, continuous over-
load, transient over-voltages, and false pulse on power
up
Output Response Time
High-Speed Mode: 300 microseconds
Normal Mode: 1.8 ms
Repeatability
High-Speed Mode: 100 microseconds
Normal Mode: 150 microseconds
WORLD-BEAM QS30EDV Expert Diffuse-Mode Sensor
8 www.bannerengineering.com - tel: 763-544-3164 P/N 127755 Rev. C