Banner VALU-BEAM Series - Manual (Page 18)

18
VALU-BEAM Modifications and Accessories
All Banner VALU-BEAM sensors are available with the "QD"
(Quick-Disconnect) option (below). A 3, 4, or 5-pin connector (depending upon the VALU-BEAM model), built into the sensor's base, mates with the SJT-type
quick disconnect cable described below. Cable must be ordered separately.
The diagrams below show pin configurations for 3, 4, and 5 pin "QD" connectors, which are located
at the base of VALU-BEAM sensors having the "QD" option. Mirror-image pin numbering is used
for the connectors of the mating cables, as shown below. Male contact pins are used in the sensor
connectors. The cable connectors have female receptacles for wiring safety.
Standard VALU-BEAM sensors (non-"QD" models, which are normally supplied with an attached
6-foot long PVC-covered cable) may instead be supplied optionally with an attached 30-foot PVC-
covered cable. Thirty feet is the most readily available length, but lengths longer than 30 feet may
also be quoted.
Quick-Disconnect ("QD") Cable Option
Pin Configurations for 3-, 4-, and 5-pin "QD" Connectors
Side View, MBCC QD Cable Connector
Dimensions, "QD" Sensors
912 Series sensors with
solid-state relay output 915 Series sensors with
e/m relay output
990 Series sensors with
built-in totalizing
counters
QD cable model
and end view
MBCC-312
MBCC-412
MBCC-512
All AC sensors:
model prefixes SM2A912,
SM2A91R, SMA912, SMA91R
All emitters:
model prefix SMA91E
All DC sensors:
model prefix SM912
(not used)
All emitters:
model prefix SMA91E
(not used)
All sensors (except emitters):
model prefixes
SMA915, SMA91R,
SMB915, SMB91R
SMW915, SMW91R
All sensors:
model prefixes
SMA990, SMA91E
(not used)
(not used)
Quick Disconnect Cables for VALU-BEAM ® Sensors with "QD" Option
(cables must be purchased separately)