Banner D11 Series - Manual (Page 4)

Action Indicator Status
Red LED: Pulses to indicate relative received signal strength
TEACH Condition #1
Present the first sensing condition to the sensor and single-click
the button.
3
This condition corresponds to the sensor output ON state.
Green: Flashes at 2 Hz
Yellow: OFF
Red: Pulses to indicate relative received signal strength.
TEACH Condition #2
Present the second sensing condition to the sensor and single-
click the button.
This condition corresponds to the sensor output OFF state. Green, Yellow, and Red indicators flash simultaneously one to four
times to indicate relative sensing contrast (see chart above).
After a few seconds, the sensor returns to RUN mode.
Output Pulse Stretcher
A 40 millisecond pulse stretcher (OFF-delay) may be enabled for applications where a very short sensing event might be missed because
of the response of the load or input connected to the sensor output. Turn the pulse stretcher ON or OFF using the following procedure.
Action Indicator Status
Push and hold the button for more than 2 seconds. Green LED: Flashes at 1 Hz
Amber LED: Off
Red LED: Pulses to indicate relative received signal strength
Pulse Stretcher
Double-click the button to display status.
Single-click the button to toggle pulse stretcher ON or OFF Pulse Stretcher ON
Green: Off
Amber: Off
Red: Solid on
Pulse Stretcher OFF
Green: Off
Amber: Off
Red: Double-flash
Double-click the button to save the configuration and return to Run
mode. See Run Mode on page 2
Hookup Diagrams
Sensors with NPN (Sinking) Outputs Sensors with PNP (Sourcing) Outputs
bn
bu
−
+
bk
wh
Load
10-30V dc
Load
Remote programming
switch (normally open)
Figure 1. Cabled Hookup
bn
bu
−
+
bk
wh
Load
10-30V dc
Load
Remote programming
switch (normally open)
Figure 2. Cabled Hookup
3 The sensor returns to RUN mode if the first TEACH condition is not registered within 20 seconds. TEACH mode may be cancelled before either condition #1 or #2 by pressing the push
button for more than 2 seconds.
D11 Expert Series
4 www.bannerengineering.com - tel: 763-544-3164 P/N 44279 Rev. C