Banner D12 Series - Manual (Page 4)

Dimensions
Glass Fiber Optic Models
20.2 mm
(0.79")
35.5 mm
(1.40")
Fiber-retaining Clip
(Supplied with Sensor)
7-Segment Display
Output Indicator
Power Indicator
Push Button
Pull to Relase
Bracket
5.0 mm
(0.20") Glass Fiber Receiver Port
Glass Fiber Emitter Port
Mounting Bracket
(Included)
12.0 mm
(0.47")
30.0 mm
(1.18")
64.4 mm
(2.52")
Glass Fiber Installation.
1. Slide the sensor ends of the fiber(s) into the D12 Expert fiber ports as far as they will go.
2. Push firmly on the fiber ends to compress the o-rings (supplied with the fibers) and to align the grooves in the fiber ends with the
slot above the emitter port. Slide the retaining clip into the slot and press the clip until it snaps into the grooves.
Plastic Fiber Optic Models
20.2 mm
(0.79")
35.5 mm
(1.40")
Fiber Gripper –
Slide up to install or
release fibers
7-Segment display
Output indicator
Power indicator
Push button
Pull to release
bracket
5.0 mm
(0.20")
Plastic fiber receiver port
Plastic fiber emitter port
Mounting bracket
(included)
Small fiber adapter
12.0 mm
(0.47")
30.0 mm
(1.18")
64.4 mm
(2.52")
Plastic Fiber Installation.
1. Cut fiber ends per instructions included with the fibers. Slide the fiber gripper up (open). (For 0.010 inch or 0.020 inch diameter
fibers, insert the small fiber adaptor into the ports as far as it will go.)
2. Insert the prepared plastic fiber sensor ends gently into the ports as far as they will go.
3. Slide the fiber gripper back down to lock.
D12 Expert Series - TEACH-Mode Fiber Optic Sensors
4 www.bannerengineering.com - tel: 763-544-3164 P/N 041974 Rev. D