Metrohm 871 Advanced Bioscan - Manual (Page 17)

2.1 Setting up the instrument
871 Advanced Bioscan / Instructions for Use 8.871.1003
9
2 Installation
2.1 Setting up the instrumen
2.1.1 Packaging
The 8 an is ith the separately
packed accessories in special p ining shock-absorbing
foam linings designed to provide excellent protection. The actual
instruments are packed in an evacuated polyethylene bag to prevent
the ingress o lease store ckaging as only it can
assure transport of the instruments free from damage.
2.1.2 Check
t
71 Advanced Biosc supplied together w
ackaging conta
f dust. P all this special pa
ed Biosca
whether the shipme
ty".
aboratory at a location convenient
m.
influences on the insulated column
including pump and eluent re
To unpack the 871 Advanced Bioscan, lift it from its box by both
hands. Never lift the 871 Advanc n at its front doors, but at its
sides.
After receipt, immediately check nt is complete and
has arrived without damage (compare with delivery note and list of
accessories in section 5.2). In the case of transport damage, see
instructions in section 5.4 "Warran
2.1.3 Location
Position the instruments in the l for
operation, free from vibrations and protected against a corrosive at-
mosphere and contamination by chemicals. The same applies to all
other components of the IC syste
To avoid disturbing temperature
compartment, the entire system servoir
must be protected against direct sunlight.
2.1.4 Arrangement of the instruments
In general, the IC pumps should be set up at the very bottom and the
IC detectors at the very top.
2.2 Mains connection
Follow the instructions below for connecting to the power supply. If the
instrument is operated with wrong mains fuse, there is a danger of fire!