Metrohm 857 Titrando - Manual (Page 28)

4 Appendix
24 825 Lab Link, Instructions for Use
If other settings should be necessary then proceed as follows:
Via
3. SETUP Port 0 (Serial)
and
2. UART Setup
you can access the required submenu for the configuration of the
RS 232 parameters:
*** Port:0 / Menu Level:2 ***********
(19200,N,8,1,N)
1. Baud:
2. Parity:
3. Data Bits:
4. Stopbit:
5. Handshake:
Press (q=quit):
After you have made the appropriate entries you can return to the
main menu (Menu level:0) by pressing the key several
times.
4.1.3 Save new configuration
Store the new configuration in the main menu with
4. SAVE Setup
Note! The IP address, Subnet Mask and Gateway are basic pa-
rameters that are also required by the 825 Lab Link for the current
Telnet session. For this reason the stored settings only become
effective after the Telnet session has been properly concluded by
entering "q“ in the main menu.