Metrohm 857 Titrando - Manual (Page 10)

2 Installation
6 825 Lab Link, Instructions for Use
4 Start communication
With the terminal connection opened hold down the
key on the PC while you switch on the Titrando at the
Touch Control. This starts a program for configuration of
the IP address in the 825 Lab Link; after approx. 2 seconds
the following prompt appears on the PC monitor:
IP no.+: _
5 Enter IP address
Enter the new IP address without any leading zeros (e.g.
10.157.213.23) and then operate the ENTER key. These
characters are not visible at first. A successfully stored IP
address will be shown:
IP no.+:
010.157.213.023
If a faulty entry is made then the message 'Fail' will
appear. In this case repeat the procedure from 4 .
The 825 Lab Link is now properly configured. If any further adap-
tations for TCP/IP or RS 232 communication are necessary then
these can be carried out as described in Section 4.1.