Metrohm 857 Titrando - Manual (Page 24)

3 Starting Lab Link
20 825 Lab Link, Instructions for Use
3 Starting Lab Link
3.1 Setting up a connection
Always start the 825 Lab Link Server software before you switch
on the Touch Control!
As soon as you have started the 825 Lab Link Server software or
have edited or defined a new connection the program will attempt
to make a connection to the 825 Lab Link hardware.
If this is successful then the Connection status will change to
connected. Otherwise the server will make regular attempts to set
up the connection. This is indicated in the status line at the lower
margin of the window. An existing connection (status connected)
will also be checked at regular intervals to see if it is still active.