3 installation, 1 about this chapter, 2 initial installation – Metrohm 850 Professional IC Anion MCS LP-Gradient User Manual
Page 23: About this chapter, Initial installation
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
850 Professional IC – Anion – MCS – LP Gradient
￭￭￭￭￭￭￭￭
13
3 Installation
3.1
About this chapter
The Installation chapter contains
￭
this overview
￭
a brief set of instructions for the initial installation of the 850 Professio-
nal IC – Anion – MCS – LP Gradient (see Chapter 3.2, page 13) as an
isocratic system. At each step you will find cross-references to more
detailed installation instructions for individual components, should you
require such aids.
￭
a brief set of instructions for the initial installation of the low pressure
gradient (see Chapter 3.3, page 16). At each step you will find cross-
references to more detailed installation instructions for individual com-
ponents, should you require such aids.
￭
an installation diagram (see Figure 3, page 18), showing a com-
pletely installed instrument.
￭
several chapters with detailed installation instructions for all compo-
nents, including those that are already installed at the time the instru-
ment is delivered.
3.2
Initial installation
Note
A large number of the capillary connections are already connected at
the time the instrument is delivered.
The 850 Professional IC – Anion – MCS – LP Gradient is supplied the same
way as an isocratic instrument, i.e. it can be put into operation with mini-
mum effort for usage with only one eluent. Carry out the following steps:
Installing 850 Professional IC – Anion – MCS – LP Gradient
1 Setting up the instrument
2 Installations on the rear of the instrument
￭