Brother DCP-7020 User Manual
Page 42
Chapter 6
6 - 2
Machine too Hot
The inside of the machine is too hot.
Make sure you can hear the fan in the DCP spinning
and the exhaust outlet isn't blocked by something.
If the fan is spinning, remove some obstacles that
surround the exhaust outlet, and then leave the DCP
for several minutes.
If the fan is not spinning, turn off the DCP and then turn
it on again.
No cartridge
The toner cartridge is not installed
properly.
Reinstall the toner cartridge.
No Paper Fed
The DCP is out of paper or paper is not
properly loaded in the paper tray.
Refill the paper in the paper tray and then press Start.
—OR—
Remove the paper and load it again and then press
Start.
Out of Memory
The DCP’s memory is full.
(Copy operation in process)
Press Stop/Exit and wait until the other operations in
process finish and then try again.
(Printing operation in process)
Reduce print resolution. (See Advanced tab in the
Software User’s Guide on the CD-ROM.)
Paper jam Inside
The paper is jammed inside the DCP.
Paper Jam Rear
The paper is jammed in the back of the
DCP.
Paper Jam Tray
The paper is jammed in the paper tray
of the DCP.
Scanner Locked
The scanner needs to be reset.
Turn off the DCP and then turn it on again.
Toner Life End
The toner cartridge and drum unit
assembly are not installed.
—OR—
Toner is used up and printing is not
possible.
Re-install the toner cartridge and drum unit assembly.
—OR—
Replace the toner cartridge with a new one. (See
Replacing the toner cartridge (TN-350) on page 6-19.)
Toner Low
The toner cartridge is near the end of its
life and the toner will soon run out.
Order a new toner cartridge now.
Unable to Init.
(Initialize)
Unable to Print
Unable to Scan
The DCP has a mechanical problem.
Turn off the DCP’s power switch, and then on again, If
the error message continues, leave the DCP for
several minutes and try it again.
ERROR MESSAGES
ERROR MESSAGE
CAUSE
ACTION