Brother DCP-7020 - Manual (Page 23)

Introduction
1 - 10
1
How to load paper
To load paper or other media in the
paper tray
1
Pull the paper tray completely out of the
DCP.
2
While pressing the paper guide release
lever, slide the adjusters to fit the paper
size.
Check that the guides are firmly in the
slots.
Note
For Legal size paper, pull out the back of the
paper tray while holding the inside latch of the
tray.
3
Fan the stack of paper well to avoid
paper jams and mis-feeds.
4
Put paper in the paper tray.
5
Put the paper tray firmly back in the DCP
and unfold the output paper tray support
flap before you use the DCP.
Note
When you put paper in the paper tray, please
remember the following:
■
Check that the paper is flat in the tray and
below the maximum paper mark, and that
the paper guides are touching the sides of
the paper stack.
■
The side to be printed on must be face
down.
Maximum Paper Mark
Output Paper
Tray Support
Flap