Metrohm 815 Robotic USB Sample Processor XL - Manual (Page 49)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Installation
815 Robotic USB Sample Processor XL ￭￭￭￭￭￭￭￭ 41
Mounting the base plate
6.2001.070
1
2
3
4
5
6
Figure 31 Mounting the base plate
Proceed as follows:
1 Insert the enclosed countersunk screw from below into the opening
on the very back of the base plate.
2 Place the washer (flat side upwards) over the countersunk screw and
tighten the support rod with the countersunk screw. The necessary
hexagon key is enclosed with the 815 Robotic USB Sample Processor
XL.
3 Hang the base plate to the assembly rail of the turntable with the
holding clamps. Slide the whole stand plate as near to the tower as
possible. Fix the holding clamps with a hexagon key to the assembly
rail.
Note
Before the stand plate is fixed to the tower, e.g. a magnetic stirrer
or a measuring cell can be mounted on the support rod.
4 Guide the bracing from above over the support rod.