Metrohm 815 Robotic USB Sample Processor XL - Manual (Page 25)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Installation
815 Robotic USB Sample Processor XL ￭￭￭￭￭￭￭￭ 17
3.4 Mounting the Swing Head to the Sample Processor
3.4.1 Mounting the Swing Head
Dismounting the titration head holder
1
1
2
1 Loosen the screws of the holder on both sides.
2 Loosen and remove the holder from the holder plate of the guide
chain.
Use the hexagon key provided. The screws will be needed again later.
Connecting the Swing Head
The connection socket (Mini DIN) for the Swing Head drive is each located
on the rear of the tower next to the stirrer connector.
Figure 8 Connecting Swing Head
Connect the Swing Head as follows:
1 Plug in the cable
￭ Guide the connection cable of the Swing Head through the guide
chain of the tower (see Chapter 3.4.2, page 19).