Cyclopital3D FinePix Real 3D W1 camera - Manual (Page 60)

46
Printing Pictures via USB ( D Only)
Printing Selected Pictures Printing Selected Pictures
1 Press the selector left or right to dis-
play a picture you wish to print.
1 Note
To print one copy of the current picture, proceed
directly to Step 3.
2 Press the selector up or down to
choose the number of copies (up to
99). Repeat steps 1–2 to select addi-
tional pictures.
3 Press MENU/OK to display a confi rma-
tion dialog.
YES CANCEL
PRINT THESE FRAMES
TOTAL: 9 SHEETS
4 Press MENU/OK to start printing.
2 Tip: Printing the Date of Recording
To print the date of recording on pictures, press DISP/
BACK in steps 1–2 to display the PictBridge menu (see
“Printing the DPOF Print Order,” below). Press the se-
lector up or down to highlight PRINT WITH DATE
s
and press MENU/OK to return to the PictBridge display
(to print pictures without the date of recording, select
PRINT WITHOUT DATE). To ensure that the date is cor-
rect, set the camera clock before taking pictures. Note
that the PRINT WITH DATE
s option is only available
with printers that support date printing.
During Printing
The message shown at right is
displayed during printing. Press
DISP/BACK to cancel before all
pictures are printed (depending
on the printer, printing may end
before the current picture has printed).
If printing is interrupted, press a to turn the camera
off and then on again.
CANCEL
PRINTING
Disconnecting the Camera
Confi rm that the above message is not displayed and
turn the camera off . Disconnect the USB cable.