Cyclopital3D FinePix Real 3D W1 camera - Manual (Page 104)

90
Caring for the Camera
To ensure continued enjoyment of the product, observe the following precautions.
Storage and Use Storage and Use
If the camera will not be used for an extended pe-
riod, remove the battery and memory card. Do
not store or use the camera in locations that are:
• exposed to rain, steam, or smoke
• very humid or extremely dusty
• exposed to direct sunlight or very high tempera-
tures, such as in a closed vehicle on a sunny day
• extremely cold
• subject to strong vibration
• exposed to strong magnetic fi elds, such as near
a broadcasting antenna, power line, radar emit-
ter, motor, transformer, or magnet
• in contact with volatile chemicals such as pesti-
cides
• next to rubber or vinyl products
■ ■ Water and Sand Water and Sand
Exposure to water and sand can also damage the
camera and its internal circuitry and mechanisms.
When using the camera at the beach or seaside,
avoid exposing the camera to water or sand. Do
not place the camera on a wet surface.
■ ■ Condensation Condensation
Sudden increases in temperature, such as occur
when entering a heated building on a cold day,
can cause condensation inside the camera. If this
occurs, turn the camera off and wait an hour be-
fore turning it on again. If condensation forms on
the memory card, remove the card and wait for
the condensation to dissipate.
Cleaning Cleaning
Use a blower to remove dust from the lens and
monitor, then gently wipe with a soft, dry cloth.
Any remaining stains can be removed by wiping
gently with a piece of FUJIFILM lens-cleaning pa-
per to which a small amount of lens-cleaning fl uid
has been applied. Care should be taken to avoid
scratching the lens or monitor. The camera body
can be cleaned with a soft, dry cloth. Do not use
alcohol, thinner, or other volatile chemicals.
Traveling Traveling
Keep the camera in your carry-on baggage.
Checked baggage may suff er violent shocks that
could damage the camera.