ClearCube I/Port Quick Reference Guide - Manual (Page 8)

4 • Introduction ClearCube I/Port User’s Guide, Rev. C
Safety Guidelines
Before undertaking any troubleshooting or maintenance procedure, read carefully all
WARNING and CAUTION notices. This equipment contains voltage hazardous to
human life and is capable of inflicting personal injury.
• Installations – ClearCube equipment is required to be installed in accordance
with the local electrical codes and may be subject to inspection by the authority
having jurisdiction.
• Chassis Grounding – ClearCube’s chassis and Fiber Transceiver has been
designed with a three-conductor IEC 60320 appliance inlet that – with the proper
power cord – connects the building’s external protective earthing conductor to all
accessible metal parts of the enclosure. To minimize shock hazard, make sure
your electrical power outlet has an appropriate earth safety ground that is
connected each time you power on the equipment.
Swedish safety regulations require the following statement:
—Apparaten skall anslutas till jordat uttag när den anslutas till ett nätuerk.—
Finnish safety regulations require the following statement:
— Laite on liitettävä suojamaadoituskoskettimilla varustettuun pistorasiaan.—
• Power Cord Selection – ClearCube or ClearCube’s Distributors provides power
cords that are specifically designed for use with that particular piece of equipment
and are approved for use by the local authority having jurisdiction in the country
where the equipment is put into service. Please refer to the installation sections of
this manual for specific power cord requirements. For replacement of power
cords, refer to Appendix C – Technical Support.
• Power Adapters – ClearCube or ClearCube’s Distributors provides power
adapters that are specifically designed for use with that particular piece of
equipment and are approved for use by the local authority having jurisdiction in
the country where the equipment is put into service. Please refer to the installation
sections of this manual for specific power cord requirements. For replacement of
power cords, refer to Appendix C – Technical Support.
• IT Power Systems – ClearCube equipment has been evaluated and found to be
compatible with IT power distribution systems with a phase-to-phase voltage not
to exceed 240 V.
• Live Circuits – Operating personnel and service personnel must not remove
protective covers when operating the ClearCube chassis. Adjustments and
service to internal components must be undertaken by qualified service
technicians. During any service of this product other than replacing a PC blade or
the fan tray, the main connector to the premise wiring must be disconnected.
Dangerous voltages may be present under certain conditions. Use extreme
caution.
• Explosive Atmosphere – Do not operate the chassis in conditions where
flammable gases are present. Under such conditions this equipment is unsafe
and may ignite the gases or gas fumes.
• Part Replacement – Only service equipment with parts that are exact
replacements, both electrically and mechanically. Contact ClearCube Technology
for replacement part information. Installation of parts that are not direct