ClearCube I/Port Quick Reference Guide - Manual (Page 28)

24 • I/Port Installation ClearCube I/Port User’s Guide, Rev. C
Server Connection
List
The default selections include:
• Autodetection
• TS 2
• TS 3
The default active connection is Autodetection. This selection’s name cannot be
edited. The names of the other two choices can be edited. To activate or deactivate a
connection, highlight it in the list and click the Enable/Disable button. To edit a
connection, highlight it and click the Edit button.
Edit Connection Profile Dialog
Connection name
This editable field specifies the name of the specified connection.
Autoconnect
Enabled
This button allows turning on Autoconnect. The default is Off (unchecked). If Enabled
(checked), the I8330 automatically connects to the system whose IP address is entered
in the Server Network Address field.
Server Network
Address
This editable field specifies the IP address of a blade to which the I8330 automatically
connects. The I83xx Driver or the I83xx Admin Utility must be installed on this blade for
a connection to be made. If the I83xx Driver is installed, the connection is a direct
connection. If the I83xx Admin Utility is installed, a Sentral login is displayed.
User name This editable field specifies the user name for this I8330. Entry is optional.
Desktop size
This radio-button menu specifies the Connection mode. Choices include combinations
of the following:
• 640 x 480
– 256 Colors (8-bit) or HI-Color (16-bit) (default)
– 60 Hz or 75 Hz vertical sync
• 800 x 600
– 256 Colors (8-bit) or HI-Color (16-bit)
– 60 Hz or 75 Hz vertical sync
• 1024 x 768
– 256 Colors (8-bit) or HI-Color (16-bit)
• 1280 x 1024 HI-Color (16-bit), 63 Hz
The default selection is 640 x 480 256 Color at 60Hz.
Mode Test The Mode Test button allows testing a video connection mode before saving it.
Password Tab
Setup Password
These buttons allow setting a password on the I8330 device setup options. Choices
include:
• Do not use Password
• Protect device Setup Options with Password
The default selection is Do not use Password.
Update Tab
Update
Select this button to update the I8330 firmware.
Misc Tab
TouchScreen
options
These buttons allow enabling support for a touchscreen device. Choices include:
• TouchScreen 3M SC3 Controller support
• TouchScreen HT ECS4-1 Controller support
The choices refer to the chipset in the touchscreen device. The default selection is
TouchScreen 3M SC3 Controller support.
NOTE: As of the initial release of the I8330 I/Port, ClearCube has not certified any
touchscreen devices for use with the I8330 I/Port. This functionality is unsupported.
Table 1 I8330 Setup Tabs (Continued)
Option Description