Brother DCP-7045N - Manual (Page 71)

Troubleshooting and routine maintenance
63
B
Cleaning the scanner glass
B
a
Turn off the machine’s power switch.
Disconnect all cables and then unplug
the power cord from the electrical
socket.
b
Lift the document cover (1).
Clean the white plastic surface (2) and
scanner glass (3) underneath it with a
soft lint-free cloth moistened with water.
c
(DCP-7045N only) In the ADF unit,
clean the white bar (1) and the scanner
glass strip (2) underneath it with a soft
lint-free cloth moistened with water.
d
Plug the machine’s power cord back into
the electrical socket first, and then
reconnect all cables. Turn on the
machine’s power switch.
Note
In addition to cleaning the scanner glass
and glass strip with a soft lint-free cloth
moistened with water, run your finger tip
over the glass to see if you can feel
anything on it. If you feel dirt or debris,
clean the glass again concentrating on
that area. You may need to repeat the
cleaning process three or four times. To
test, make a copy after each cleaning.
Cleaning the laser scanner
window
B
WARNING
Use neutral detergents.
DO NOT use any flammable substances,
spray or organic solvent/liquids containing
alcohol/ammonia to clean the inside or
outside of the machine. Doing this may
cause a fire or electrical shock. For more
information see Important safety
instructions on page 40.
CAUTION
DO NOT touch the laser scanner window
with your fingers.
a
Before you clean the inside of the
machine, turn off the machine’s power
switch.
Unplug the power cord from the
electrical socket.
1
3
2
1
2