Brother DCP-7045N - Manual (Page 20)

Chapter 2
12
Paper capacity of the paper trays
2
Recommended paper specifications
2
The following paper specifications are suitable for this machine.
Handling and using special
paper
2
The machine is designed to work well with
most types of xerographic and bond paper.
However, some paper variables may have an
effect on print quality or handling reliability.
Always test samples of paper before
purchasing to ensure desirable performance.
Store paper in its original packaging and keep
it sealed. Keep the paper flat and away from
moisture, direct sunlight and heat.
Some important guidelines when selecting
paper are:
„ Do not use inkjet paper because it may
cause a paper jam or damage your
machine.
„ Preprinted paper must use ink that can
withstand the temperature of the
machine’s fusing process (200 degrees
centigrade).
„ If you use bond paper, paper having a
rough surface or paper that is wrinkled or
creased, the paper may exhibit degraded
performance.
Paper size Paper types No. of sheets
Paper Tray A4, Letter, Executive,
A5, A6, B5, B6. Plain paper and recycled
paper up to 250
[80 g/m 2 ]
Transparency up to 10
Manual Feed Slot Width: 76.2 to 220 mm
Length: 116 to 406.4 mm
Plain paper, recycled
paper, bond paper,
envelopes, labels and
transparencies 1
Basis weight 75-90 (g/m 2 )
Thickness 80-110 µm
Roughness Higher than 20 sec.
Stiffness 90-150 cm 3 /100
Grain direction Long grain
Volume resistivity 10e 9 -10e 11 ohm
Surface resistivity
10e 9 -10e 12 ohm-cm
Filler CaCO
3
(Neutral)
Ash content Below 23 wt%
Brightness Higher than 80 %
Opacity Higher than 85 %