Brother DCP-7045N - Manual (Page 21)

Loading paper and documents
13
2
Types of paper to avoid
2
CAUTION
Some types of paper may not perform well
or may cause damage to your machine.
DO NOT use paper:
• that is highly textured
• that is extremely smooth or shiny
• that is curled or warped
1 2 mm
• that is coated or has a chemical finish
• that is damaged, creased or folded
• that exceeds the recommended weight
specification in this guide
• with tabs and staples
• with letterheads using low temperature
dyes or thermography
• that is multipart or carbonless
• that is designed for inkjet printing
If you use any of the types of paper listed
above, they may damage your machine.
This damage is not covered under any
Brother warranty or service agreement.
Envelopes
2
Most envelopes will be suitable for your
machine. However, some envelopes may
have feed and print-quality problems
because of the way they have been made. A
suitable envelope should have edges with
straight, well-creased folds and the leading
edge should not be thicker than two sheets of
paper. The envelope should lie flat and not be
of baggy or flimsy construction. You should
buy quality envelopes from a supplier who
understands that you will be using the
envelopes in a laser machine.
Envelopes can be fed from manual feed slot
one at a time. We recommend that you print
a test envelope to make sure the print results
are what you want before you print or
purchase a large quantity of envelopes.
Check the following:
„ Envelopes should have a lengthwise
sealing flap.
„ The sealing flaps should be folded crisply
and correctly (irregularly cut or folded
envelopes may cause paper jams).
„ Envelopes should consist of two layers of
paper in the area circled in figure below.
1 Feeding direction
„ We recommend that you do not print
within 15 mm of the edges of envelopes.
„ Envelope joints that are sealed by the
manufacturer should be secure.
1
1
1 1