Brother DCP-7045N - Manual (Page 63)

Troubleshooting and routine maintenance
55
B
Fuser Error The temperature of fuser unit
does not rise at a specified
temperature within specified time. Turn the power switch off, wait a few
seconds, and then turn it on again. Leave the
machine for 15 minutes with the power on.
The fuser unit is too hot.
Init Unable XX The machine has a mechanical
problem. Disconnect the machine from the power for
several minutes and then reconnect it.
Jam Rear The paper is jammed in the back
of the machine. (See Paper jams on page 57.)
Jam Inside The paper is jammed inside the
machine. (See Paper jams on page 57.)
Jam Tray The paper is jammed in the paper
tray of the machine. (See Paper jams on page 57.)
No Paper The machine is out of paper or
paper is not correctly loaded in
the paper tray. Do one of the following:
„ Refill the paper in the paper tray, and
then press Start.
„ Remove the paper and load it again, and
then press Start.
Out of Memory The machine’s memory is full. Copy operation in progress
Do one of the following:
„ Press Start to copy the scanned pages.
„ Press Stop/Exit and wait until the other
operations in progress finish, and then try
again.
„ Clear the data from the memory. (See
Out of memory message on page 27.)
Print operation in process
Reduce print resolution. (See Advanced tab
in the Software User’s Guide on the
CD-ROM.)
Print Unable XX The machine has a mechanical
problem. Disconnect the machine from the power for
several minutes and then reconnect it.
Scan Unable XX The machine has a mechanical
problem. Disconnect the machine from the power for
several minutes and then reconnect it.
Toner Life End The drum unit and toner cartridge
assembly is not installed
correctly, or the toner cartridge is
used up and printing is not
possible. Do one of the following:
„ Re-install the toner cartridge and drum
unit assembly.
„ Replace the empty toner cartridge with a
new one. (See Replacing a toner
cartridge on page 69.)
Error Message Cause Action