Bully Dog 3330x Custom Gauge Pods - Manual (Page 23)

22
If the vehicle has a speaker attached to the A-pillar, the speaker
will need to be removed before the trim piece can be completely
removed.
4. To remove the speaker:
a. Disconnect the speaker
wire. (The plug is located
about 4” away from the
speaker.)
b. Release the securing tabs
by pushing them outward
from the speaker.
c. Push the speaker out of
the trim piece.
5. To install the speaker in the custom gauge pod:
a. Run the speaker wire
through the front of the
speaker hole.
b. Line up the speaker and
snap it into place.
6. Attach the GT, WatchDog or
PMT cradle to the custom
gauge pod. (See diagrams on
pages 3 and 4.)
7. Peel the clear strip(s) off the adhesive tape on the back
of the pod mount.
Disconnect Speaker
Install Speaker in Pod
Attach GT, WatchDog or PMT
cradle to gauge pod.