Bully Dog 3330x Custom Gauge Pods - Manual (Page 13)

12
4. Peel the clear strip(s) off the adhesive tape on the back
of the pod mount.
5. Position the custom
gauge pod over the
stock A-pillar. (Do not
attach or secure it yet.)
6. Route all wiring under
the gauge pod (and
under the dash, if
necessary).
7. Slide the pod down
until the pod screw
hole lines up with the
screw hole on the
stock A-pillar.
a. Be careful not to
touch the pod to
the pillar (adhesive
tape).
8. Use the provided bolt
(not the stock bolt) to secure the gauge pod and the
stock A-pillar to the vehicle frame.
9. Firmly press down on the parts of the pod mount where
the adhesive tape touches the stock A-pillar for a
secure attachment.
10. Re-secure the weather stripping.
Line up the Pod
Position the pod on the A-Pillar