Bully Dog 3330x Custom Gauge Pods - Manual (Page 16)

15
8. Line up the gauge pod.
a. Be careful not to touch the pod to the vehicle
(adhesive tape).
b. The bottom of the pod should match the bottom of
the A-pillar.
PMT installs: skip step 9.
9. Make sure that the HDMI cable is sticking out through
the gauge hole.
10. Slide the pod down until the pod screw hole lines up
with the screw hole on the stock A-pillar.
a. Be careful not to touch the pod to the pillar
(adhesive tape).
11. Use the provided bolt (not the stock bolt) to secure the
gauge pod and the stock A-pillar to the vehicle frame.