Bully Dog 3330x Custom Gauge Pods - Manual (Page 11)

10
3. Pull back weather stripping in the area of the A-pillar and
remove the side panel of the dash by the driver door.
4. Run cables as needed through the dash to the custom
pod. Install the custom gauge pod by first aligning the
tab into the slot on dash. Guide custom gauge pod so
the screw hole lines up with the stock screw hole. Secure
using the supplied screw, not the stock screw.
5. Secure the weather stripping, install the side panel and
the job is finished. Enjoy your Bully Dog Custom Pod
Mount!
Tab
Install
Screw