Bird Technologies MSCC7 Series-Manual - Manual (Page 27)

Maintenance
13
1. Disconnect the RF line from the Cal Cart.
2. Remove the Cal Cart front panel (see "Front Panel" on page 12).
3. Disconnect the sensor cable from the power sensor.
4. Disconnect the RF cable from the sensor output port.
5. Remove the screws on the sensor mounting bracket.
6. Remove the sensor from the mounting bracket.
7. Put the new sensor in the bracket and screw it into place.
Note: Make sure the arrow on the side of the sensor points towards
the load, and that the end labeled “SOURCE” points towards the front
of the Cal Cart.
8. Connect the RF cable to the sensor end labeled “LOAD”.
Note: Connect the sensor cable.
9. Replace the Cal Cart front panel.
Load
1. Disconnect the RF cables from the RF connectors on the load.
2. On blower-equipped loads, unplug the blower assembly.
3. Replace the vent plugs with the shipping plugs.
4. Remove the mounting bolts connecting the load to the Cal Cart.
5. Remove the load.
Casters
1. Remove the load (See "Load" on page 13).
2. Flip the cart over.
3. Unscrew the defective caster.
4. Screw the new caster into place and replace the load.
Handle
1. Unscrew and remove the old handle.
2. Screw the new handle into place.
Storage and Shipment
Storing the Load Resistor
z Cover the cal cart before storing to keep out dust and dirt.
z It is not necessary to install the shipping plug.
z Store in a dry, dust-free environment where the ambient temperature
will remain between –40 and +45 °C (–40 to +113 °F).
Shipping the Load Resistor
1. Remove the vent plug.
2. Install the shipping plug.
3. Wrap the vent plug with padding and tape it to the side of the load for protection.
Note: With the shipping plug installed, it is not necessary to empty
out the coolant.
4. Wrap the connector in padding.
5. Pack and brace the load in a sturdy wooden crate for shipment.
WARNING
Heavy load. Do not attempt to lift unaided.