Bang & Olufsen BeoSystem 1 - User Guide - Manual (Page 42)

42 >> Set up BeoSystem 1
Connect a screen to BeoSystem 1
BeoSystem 1 is intended for use with a
plasma screen. However, it also supports the
use of a front projector, rear projector, or
LCD screen. You can also connect a home
automation system to BeoSystem 1, and
thereby control room lights and curtains
when BeoSystem 1 is switched off.
IMPORTANT! The screen you connect to
BeoSystem 1 must be compatible with 50 Hz
input!
The diagrams show examples of BeoSystem 1 in
setups with, respectively, a plasma screen/LCD
screen, a projector and a home automation system.
More than one screen type can be connected at
one time.
The diagrams are provided as examples, and there-
fore may not apply to your particular screen. Your
installer should set up your screen and connect it
to BeoSystem 1.
RGB
RS232
IR IN
RGB
0/12V
CONTROL
IR IN
0/12V CONTROL
BeoSystem 1 connected to a plasma screen or LCD screen.
BeoSystem 1 connected to a projector.
BeoSystem 1 connected to a home automation system. It is only possible to connect a home automation
system in a setup with a front or rear projector.