Bang & Olufsen BeoSystem 1 - User Guide - Manual (Page 23)

23
Use your pincode
If BeoSystem 1 has been disconnected from
the mains for 15–30 minutes, BeoSystem 1
prompts you for the pincode when you switch
it on. If you do not enter the pincode,
BeoSystem 1 switches to standby after
approximately 4 minutes.
When BeoSystem 1 is
switched on…
BeoSystem 1 prompts you for
your pincode
Enter your pincode
BeoSystem 1 restarts when the
last digit is entered
If an incorrect code is entered,
ERROR is shown. Re-enter the
code
To cancel a code entry…
Press to cancel a code entry, and
the input fields are cleared
Five incorrect entries cause
BeoSystem 1 to shut down for
three hours, during which time
operation is not possible.
Approximately 20 seconds
before the system automatically
switches to standby, it cannot be
operated by remote control.
Therefore, it is not possible to
enter a pincode during this time.
Did you forget your pincode?
Contact a Bang & Olufsen retailer to receive a
five-digit mastercode.
When you have received a
mastercode…
When BeoSystem 1 prompts you
for your pincode, press and hold
l to bring up the mastercode
display
Entering this five-digit code
deactivates your pincode and
reactivates BeoSystem 1.
DELETED is displayed
To use the pincode system
again…
Follow the procedure for
activating the pincode system
PIN _ _ _ _
l
PIN _ _ _ _ _
0 – 9
DELETED
PIN _ _ _ _
0 – 9
PIN * * _ _
PIN * * * *
ERROR
PIN _ _ _ _
STOP