Ambient Lanc Logger - ALL601 - Manual (Page 8)

8
DISPLAY
The Display is a 2 colour ( yellow bar on top, rest blue) OLED with
128X64 pixels. OLED displays are small daylight readable, low power
devices and are ideal for portable equipment. The yellow bar shows the
timecode and userbits and other data of the TOD generator. Then there is
a menu bar with tablike structure. The rest of the display is used for
menu description and selection, and in “job closed” mode for showing
actual data and settings.
LEMO SOCKET
This socket has the same pin allocation as other Ambient clockit units
Pin
Function
1 Ground
2 LTC in
3 Aaton ASCII. Tx, Rx
4 Tune signal out 1.92 Mhz.
5 LTC out
BATTERY COMPARTMENT
The battery compartemnt is situated on the left side and has an anodised
aluminium hinged door containing reverse polarity protection contacts.
Care should still be taken to check correct polarity when inserting
batteries. The door is closed by closing and pushing towards the bottom
side of the ALL. The door moves to a locked position held in place by the
force of the battery springs,
To open, press in and slide the door in the opposite direction to closing.
The door will move back and spring open, shooting the batteries to
various unaccessible places! Be careful this does not happen!!
SPECIFICATION
Interfaces
• Lemo 5 pin interface Ambient /Aaton TC standard
• Battery compartment 2 X AAA with reverse polarity protection
• Two colour OLED display
• Four cursor keys with alternate functions
• Red ESC key with turn on symbol and Log function
• Green ENT key with log and quickkey function
• USB port for program upload, MIDI and Mass storgage download
•
Audio in/out (2 heavy duty 3.5mm and 2.5mm minijack sockets*) with
Electret Mike power LTC out on channel 2 (ring of minijack) and LTC in
on channel I (tip of minijack)
•
LANC in/out (2 heavy duty 3.5mm and 2.5mm minijack sockets*)
For connection to the LANC port of Sony camera and for simultaneous
connection of remote zoom control
• Infrared port for ASCII protocal comms. between Controller ACC501 and
ALL
* Connection to Lanc and Mike input of prosumer camera ( 2.5mm /
3.5mm Minijack) through universal cable supplied.