Ambient Lanc Logger - ALL601 - Manual (Page 4)

4
Mic/Audio
TC out to Camera
IR Comms
Mic/ Audio
TC/ Mic in
Lanc to
Remote
Lanc from
Camera
USB
Cursor Keys
Lemo: Aaton, Ambient TC Interface
Display
ESC / Enter
Command Keys
Batteries
DEVICE DESCRIPTION
AUDIO INTERFACE AND LTC INPUT OUTPUT
The audio interface ist a two channel unbalanced input/output with
Electret power supply (5.6Volt) on channel 1 of the input, switchable
LTC out on channel 2 output, and an auxiliary LTC input on channel 1
(when the mike is not being used).
The LTC level can be adjusted from 0db to –55db with an extra –20db
switched pad at the LTC output to audio, allowing LTC input to every
type of microphone or line input without distortion or crosstalk. On
channel 1 at the mike side is a switchable Powering of 5.6 volts that
covers the requirements of all Electret microphones.
The LTC ouput on channel 2 can be set to either off, continous ,or burst,
(triggered by the record on signal from camera LANC), allowing audio to
be recorded on channel 2 aftewr the burst.
• Electret Mike power supply
• LTC output with adjustable levels,
• LTC switchable as burst, continuous, or off
• LTC auxiliary input
ALL 601
PORTS AND
ACCESS