Ambient Lanc Logger - ALL601 - Manual (Page 17)

17
LANC to TOD. Using a Sony Lanc port for Rec. Run. timecode source
EXT LTC to TOD Using external Rec. Run. LTC as timecode source
KEY TOD. Using manual keystroke to mark events in TOD
Note: When logging select MODE menu to display incoming data,
cassette number and Box ID.
Note: In this menu, usually shown when Logging, to display log
data, the cassette number can be incremented quickly by using a
quickkey combination. With tab on Mode, open JOB, LOG blinks,
press up cursor then ENT to increment or down cursor then ENT
to decrement cassette number. Then Close JOB to proceed.
AUD (ATC) TC output parameters.
TC OFFSET. +-10 frames
TC LEVEL. -55dB (Mike) to 0dB (Line). 10 steps to suit the input.
OUTPUT MODE. Off, Burst, or Continuous.
UB Log and userbit ID numbers
BOX ID Camera/recording device number
CASSETTE ID cassette number
EVENT NUMBER start number
This number increments with every Log made
OPT option bit, Sets option bit in the log and TOD userbits
SYS system parameters
RTC. The real time clock
time can be set from the TOD generator or edited
date can be set from the TOD generator or edited
DISPLAY Parameters
The brightness of the display can be set
Auto off function can be turned on or off.
Note: use a display brightness that is required, not brighter. This
conserves power and prolongs display life.