AJA RH10UC - Manual (Page 9)

1
9 AJA RH10UC SD to HD Upconverter User Manual
Parameter Choices and Definitions When in HD Framesync mode
Table 5.
Parameter
(Character 1)
Definitions
(Choices are shown in italics)
0 Selects a Mode of operation for the board. Choices are:
UP—up convert
HF—high definition framesync
5 Output Timing Mode, Set Reference Source. Choices are:
R—reference input
I—video input
F—free run (default)
7 Freeze Video
ON—Freezes the output video.
OFF—Not Frozen (default).
A Display HD Input Format, possible values are:
A—No input detected
AERR— Input error detected
A1p2—HD1080psf 23.98
A1i6—HD 1080i 59.94 or 1080i 60
A1i5—HD 1080i 50
A7p6—HD 720p 59.94 or 720p 60
V Output Timing Adjust—Vertical
The maximum range changes based on the output frame rate
and the frame geometry. Switch adjusts value by lines in frame.
V delays are signed numbers, with zero timing relative to the
reference signal noted as zero (“0”). Zero is the factory default for
both V timing parameters.
The RH10UC remembers V and stores it in flash, recalling it as
needed when the output frame rate or geometry changes.
Refer to the H and V Parameter Reference Table that follows for
ranges.
H Output Timing Adjust—Horizontal
The maximum range changes based on the output frame rate
and the frame geometry. Switch adjusts value by pixels to shift
horizontally.
The factory defaults are zero-timed values as measured
empirically at AJA. They are given in the table below.
The RH10UC remembers H and stores it in flash, recalling it as
needed when the output frame rate or geometry changes.
Refer to the H and V Parameter Reference Table that follows for
ranges.
I Information—shows current software version