AJA RH10UC - Manual (Page 8)

8
7 Freeze Video
ON—Freezes the output video.
OFF—Not Frozen (default).
8 Generate test pattern:
ON—75% color bars
OFF—none (default)
9 ON—Sharp Vertical Filter. Results in sharper image, with
increased edge artifacts.
OFF—Standard Vertical Filter (default). Provides the best
possible image, although edges are not as sharp.
A Display SD Input Format, possible values are:
A—No input detected
AERR— Input error detected
A525—SD 525
A625—SD 625
H Output Timing Adjust—Horizontal
The maximum range changes based on the output frame rate
and the frame geometry. Switch adjusts value by pixels to shift
horizontally.
The factory defaults are zero-timed values as measured
empirically at AJA. They are given in the table below.
The RH10UC remembers H and stores it in flash, recalling it as
needed when the output frame rate or geometry changes.
Refer to the H and V Parameter Reference Table appearing later
in this manual for value ranges.
V Output Timing Adjust—Vertical
The maximum range changes based on the output frame rate
and the frame geometry. Switch adjusts value by lines in frame.
V delays are signed numbers, with zero timing relative to the
reference signal noted as zero (“0”). Zero is the factory default for
both V timing parameters.
The RH10UC remembers V and stores it in flash, recalling it as
needed when the output frame rate or geometry changes.
Refer to the H and V Parameter Reference Table that follows for
ranges.
I Information—shows current software version
W Set RH10UC To Factory Defaults
To set all values to factory defaults, select Param W, and move
the adjust switch to the right. This will set all parameters in the
system to factory values. After a 5 second inactivity time-out, the
values will be written to flash.
If all the values in the system match the factory defaults, either
through adjustment or by setting them as above, the display for
param W will be “WFAC”. If any of the values are different, the
display for param W will simply be “W”.
Table 4.
Parameter
(Character 1)
Definitions
(Choices are shown in italics)