AJA RH10UC - Manual (Page 5)

1
5 AJA RH10UC SD to HD Upconverter User Manual
User Controls
The user interface for the RH10UC consists of two toggle switches and a 4-
character alphanumeric display. See the photo “
RH10UC User Interface
Controls ” that follows for control location and function.
The Parameter Select (PS) switch selects a parameter for adjustment and
viewing on the display. Once a desired parameter is selected by moving the
PS switch, you then use the other switch—called
Parameter Adjust (PA)—to
make a change to the parameter setting. Both switches are toggle switches
that can be pushed to the right or left, allowing you to move forward or
backward through available choices. After actuation, either switch will
return to a middle position.
If you move a switch and hold it in place (left or right), the RH10UC will
sense this and auto-increment or decrement.
By default, the 4-character display shows the current status of the
RH10UC—referred to as status mode. When you’re adjusting parameters or
settings, the display changes from status mode to adjust mode to show the
new value settings or parameters. After a period of inactivity the display
always reverts to status mode.
RH10UC User Interface Controls
Normal
Operation Status
Mode The RH10UC display by default will show you which inputs are present, any
detected error conditions, and the functional mode the board is in
(upconverting, downconverting, HD/SD framesync, etc.). After the board is
powered on, it enters
status mode and stays there until a toggle switch is
selected and you enter adjust mode . After 5 seconds of inactivity in adjust
mode, it then returns to status mode.
While in status mode, the 4-character display indicates the following:
PS Switch
Parameter Select
PA Switch
Parameter Adjust 4-Character
Display
Switches
Toggle
Left and Right
8 8 88
1 2 3 4