beautypg.com

Rockwell Automation EK-29000-DPH01 Dual Probe Holder User Manual

Dual probe holder, Installation instructions

background image

Publication GMSI10-UM028A-EN-E - November 2007

Installation Instructions

Dual Probe Holder

Cat. No. EK-29000-DPH01

This document provides information to install the Allen-Bradley Dual Probe Holder. The
Dual Probe Holder is designed to combine a displacement transducer and an Allen-Bradley
9000 series sensor (velocity or accelerometer) into a single housing. The Dual Probe Holder
can be used in conjunction with the Allen-Bradley XM

®

-121 Absolute Shaft module to

provide shaft relative, case absolute, and shaft absolute measurements.

Note that the Dual Probe Holder is also functional with either one of the two sensors
installed.

For more information on the XM-121 Absolute Shaft module, refer to the XM-121 Absolute
Shaft User Guide (publication GMSI10-UM014x-EN-E). Refer to the specific sensor manual
for recommended wiring requirements and specifications for that sensor.

For information about

See page

Important User Information

2

About the Dual Probe Holder

3

Installing the Dual Probe Holder

6

Replacing the Sensors in Dual Probe Holder

10

Specifications

13