Rockwell Automation Logix5000 Systems: Connecting PowerFlex 40 Drives over an EtherNet/IP Network Quick Start - Manual (Page 23)

Rockwell Automation Publication IASIMP-QS029A-EN-P - February 2012 23
Add the PowerFlex 40 Drive to an RSLogix 5000 Project Chapter 2
Add the 22B-V2P3N104 Drive to Your RSLogix 5000 Project
1. Verify your RSLogix 5000 project is
offline and the Logix5000
controller mode switch is in the
PROG mode position.
2. Right-click your network port
and choose New Module.
3. Select the PowerFlex 40-E
drive and click Create.
The Select Module Type dialog
box may appear differently
depending on which
Logix5000 controller your
application uses and, thus, what
version of RSLogix 5000
software is used.
IMPORTANT The tasks described in this section use an RSLogix 5000 project for a CompactLogix 5370 L3 controller.
CompactLogix 5370 L3 controllers require that you use RSLogix 5000 software, version 20.00.00 or later.
If your are using a different Logix5000 controller, your project’s RSLogix 5000 software version requirements might
be different.
RUN
REM
PROG